>Orangutan Enrichment Catalog

Henry’s Puzzle Paradise


  • Wire mesh 1 ½ x 1 ½ inch on front and bottom of cage
  • The sides of the cage is sheet metal
  • Front of cage is H 10 ¾ x W 11 inches
  • Sides of cage are H 10 ¾ x W 14 inches
  • The sides, front, back, and bottom of cage is welded together.
  • There are also four nuts welded to the back part of the cage so the top can be put on.
  • On the front of the cage there is a latch welded on and the other piece is welded to the cage top.
  • The top of the cage is 1 ½ x 1 ½ wire mesh with a piece of sheet metal welded underneath so orangutan can not stick fingers thru to pull top off.
  • Top measurements are H 10 ¾ x W 13 ¾
  • There are 4 pieces of wire that measure 1 ½ that stick out of the tops cage total measurement would be 12 ¼ inches
  • Inside of the cage is a divider that holds the feeders in place that measures 4 inches in width you may adapt this part to the size of feeders you want to use.
(Sally Singleton – El Paso Zoo)